Turn a scene’s still into a clip in the Animate tab, and extend or edit that clip.

Animate a clip
Section titled “Animate a clip”- Select a scene with a still.
- Click Animate.
- Write the motion in the prompt.
- Pick the resolution from the caret on Animate.
- Click Animate.
You must write a prompt. It holds up to 2,000 characters. A scene without a still generates the clip from the prompt alone. The caret shows the credits for each resolution. Some resolutions are not available on every account, and those show locked.
A clip has a minimum and a maximum length. When the scene duration is outside that range, the Duration field turns amber and offers Adjust to.
Animate to next scene ends the clip on the picture of the next scene. It is off on the last scene.
Switch between still and clip
Section titled “Switch between still and clip”A scene that has a clip keeps its still. The bar under the canvas switches between Still and Clip, and V does the same. Switch to Still to edit the still, or to animate it again into a new clip.
Extend or edit a clip
Section titled “Extend or edit a clip”With Clip in view, the Animate tab offers these actions. Not every account has both.
- Extend clip (the fast-forward button) adds seconds to the end. The prompt says what happens next. An empty prompt continues the scene.
- Edit changes the clip by the prompt: make it nighttime. Where the caret offers a higher resolution, Edit with an empty prompt upscales the clip. Edit shows only for a clip whose length the edit accepts.
To change a clip’s look and keep its motion, see Refine.
Prompting guide
Section titled “Prompting guide”The still already sets the subject and the place, so write what moves and how the camera moves. A scene without a still needs more: describe the full shot, with the subject and the setting.
Match motion to energy
Section titled “Match motion to energy”Low energy suits wide shots and slow movement. High energy suits close shots and dynamic movement.
Time the action
Section titled “Time the action”Write the order of events in plain words, such as After 3 seconds she turns, or with timecodes:
[0-3s] She walks to the door. [3-6s] She reaches for the handle.One action suits a clip of 3 to 5 seconds.
Say what you want to hear
Section titled “Say what you want to hear”Clips can carry their own sound, so describe it when it matters: Ambient street noise, no music or No dialogue. When the scene has narration or the project has music, ask for ambient only, no music, no dialogue.
Connect two scenes
Section titled “Connect two scenes”Animate to next scene works when the next still continues the same shot. Derive that still first, such as the same shot and camera, five seconds later. Then describe the single move between the two pictures: she walks to the door and reaches for the handle.
Do not use it between scenes that cut to a different place or angle. The clip would morph one into the other. After three or four derived stills, go back to the establishing still as your reference.
Keep references in the prompt
Section titled “Keep references in the prompt”Mentioned pictures ride along as references. Some clip options leave references out, so check What this request sends before you run it.
